Non-IC -> IC box conversion
Posted: Sat May 16, 2009 12:52 pm
Just wondered, if a conversion could be made between the non-intercooled box to an intercooled box.
If memory serves me right the difference is a single bearing (I assume shafts are same thickness?). Would it be possible to actually strip the box and fit said part?
Just wondering as I have two boxes, one of each type and would ease the strain of my current upgrades, if I could rebuild the non-ic box over time.
Alternatively I could just temporarily fit the non-IC box, but I wouldn't trust it too much unless it was strengthened anyway.
If memory serves me right the difference is a single bearing (I assume shafts are same thickness?). Would it be possible to actually strip the box and fit said part?
Just wondering as I have two boxes, one of each type and would ease the strain of my current upgrades, if I could rebuild the non-ic box over time.
Alternatively I could just temporarily fit the non-IC box, but I wouldn't trust it too much unless it was strengthened anyway.
