changing the clock bulb rover 200/25

Post Reply
nicko500s
Spanner Twirler
Posts: 175
Joined: Fri Sep 04, 2009 11:22 pm

changing the clock bulb rover 200/25

Post by nicko500s »

remove the housing to access the 2 screws retaining the clock using a magnetic tip srewdriver or you will never see those screws again!

the housing is retained by push in lugs on either side the housing and a odd fixing on the bottom of the housing.
to remove the housing push down on the bottom part of the housing while pulling either side, yes you need 3 hands!
the one i did was harder than i thought to remove as i had never done one before and using a screw driver marked the plastic due to the force required. realisticly you can only do one side at a time but this broke the bottom fixing on the dash, still it went back on ok.
Post Reply